MacBookAir9,1: t2bce_vhci desync after rapid S3 suspend/resume cycles — 'Unhandled system event: 50' on resume, internal keyboard dead, next suspend wedges (linux-t2 7.1.8)

Summary

After several lid-close/lid-open S3 suspend/resume cycles in quick succession on a
MacBookAir9,1, one resume completes with t2bce_vhci: Unhandled system event: 50.
The next lid close (~24 s later) never reaches S3: the VHCI command channel
desyncs (Possible desync, cmd cancel timed out), the internal keyboard and
trackpad stop responding at the lock screen, a udev worker hangs indefinitely on
the trackpad evdev node, and the suspend request wedges. The machine had to be
forcibly powered off.

This uses the newer t2bce stack (v0.06), not legacy apple-bce.

Unlike #22 (hibernate/S4 resume failure followed by kernel GP faults), this is
plain S3 suspend, there is no oops, and the failure is preceded by the
Unhandled system event: 50 message — the VHCI simply desyncs and everything
that touches it hangs.

Hardware

Model: MacBookAir9,1
Board: Mac-0CFF9C7C2B63DF8D
Firmware: BIOS 2103.100.6.0.0, iBridge 23.16.15067.0.0
T2 Bridge Controller: PCI 0000:74:00.1 (106b:1801)

Software

Distribution: Omarchy / Arch Linux
Kernel: 7.1.8-arch1-Watanare-T2-3-t2 (linux-t2 7.1.8.arch1-3)
t2bce driver stack: v0.06 (drivers/staging/t2bce)
systemd 261.2-1, Hyprland 0.56.2-1
/sys/power/mem_sleep: s2idle [deep] — all sleeps below are S3 deep

Steps to reproduce

Boot normally, log in to the graphical session.
Close and open the lid several times over ~20 minutes (five S3 cycles here).
On an eventually-unlucky resume, the kernel logs
t2bce_vhci: Unhandled system event: 50 s=0 p1=0 p2=0 shortly after the
internal keyboard re-enumerates.
Close the lid again within ~30 seconds.
The VHCI desyncs; internal keyboard/trackpad are dead at the lock screen and
the suspend never enters S3. Only a forced power-off recovers.

Reproducibility is timing-dependent: four earlier cycles in the same boot —
including one where the lid was closed only 16 s after resume — survived. The
fatal cycle is the only one where Unhandled system event: 50 was logged.

Timeline (journal from the affected boot)

Suspend/resume cycles leading up to the failure:

14:24:26 PM: suspend exit
14:32:21 PM: suspend entry (deep)
14:33:04 PM: suspend exit
14:36:50 PM: suspend entry (deep)
14:39:04 PM: suspend exit
14:39:20 PM: suspend entry (deep)      <- 16 s after resume, survived
14:44:32 PM: suspend exit
14:44:58 PM: suspend entry (deep)
14:45:31 PM: suspend exit              <- fatal cycle's resume

The final resume looks normal at first (keyboard re-enumerates as usb 5-5
device 18), then the unhandled event arrives:

14:45:29.647 t2bce_core: suspend: exit status=0 stateful_valid=1 no_state_resume=0 no_state_fallback=0
14:45:29.655 t2bce_core: resume: exit status=0 path=stateful stateful_valid=0 no_state_resume=0 no_state_fallback=0
14:45:29.662 t2bce_vhci: stateful resume exit status=0
14:45:29.662 t2bce_vhci: bus_resume exit status=0 no_state_resume=0
14:45:29.727 usb 5-5: new high-speed USB device number 18 using t2bce_core
14:45:30.012 apple 0003:05AC:0280.003C: input,hiddev98,hidraw3: USB HID v1.01 Keyboard [Apple Inc. Apple Internal Keyboard / Trackpad] on usb-t2bce_vhci-5/input1
14:45:30.823 t2bce_vhci: Unhandled system event: 50 s=0 p1=0 p2=0
14:45:31.140 PM: suspend exit

Lid closed again at 14:45:55; the suspend request then wedges and the VHCI
desyncs:

14:45:55.321 systemd-logind: Suspending...
14:46:03.552 t2bce_vhci: Possible desync, cmd cancel timed out
14:46:06.624 t2bce_vhci: Possible desync, cmd cancel timed out
14:46:09.695 t2bce_vhci: Possible desync, cmd cancel timed out
14:46:10.498 systemd-logind: Delay lock is active (UID 0/root, PID 782/NetworkManager) but inhibitor timeout is reached.
14:46:10.502 systemd[1]: Starting System Suspend...
14:46:30.815 (udev-worker): event7: Spawned process '/usr/lib/udev/libinput-fuzz-to-zero /sys/devices/pci0000:00/.../t2bce_vhci/usb5/5-5/5-5:1.2/0003:05AC:0280.003D/input/input35/event7' is taking longer than 59s to complete.
14:46:40.928 t2bce_vhci: Possible desync, cmd cancel timed out

No PM: suspend entry ever follows the 14:46:10 suspend start — the freeze is
blocked on the hung VHCI — and the journal ends at 14:46:56 with the forced
power-off.

Other observations

Keyboard/trackpad input was dead the entire time; the power button (ACPI/EC
path) still woke the display, which is how the lock screen cursor could be
toggled while the keyboard stayed unresponsive.
No oops, no memory pressure, no NVMe/filesystem errors in the same window.
The user-session sleep-lock service (omarchy-sleep-lock.service) crash-looped
with "Failed to inhibit: The operation inhibition has been requested for is
already running" throughout — downstream symptom of the wedged suspend, not a
cause.
After the forced reboot the driver behaves normally again.

Questions / suggestions

What is system event 0x50? The Unhandled system event: 50 s=0 p1=0 p2=0
message 0.3 s before PM: suspend exit is the only observable difference
between this resume and the four healthy ones, so it looks like the T2 was
already signalling a state the driver did not track.
Could t2bce_vhci recover from a command-cancel timeout instead of staying
permanently desynced — e.g. tear down and re-enumerate the virtual bus (the
equivalent of the "HC died" path), so the keyboard comes back without a
forced power-off? As it stands the hang also blocks the next suspend, which
turns a driver glitch into an unclean shutdown.

Happy to provide the full journal for the affected boot or test patches.

@deqrocks

Confirming this on a MacBookPro16,1 with the same stack, and adding a second, silent variant of what looks like the same underlying desync — plus a strong correlation with the Touch Bar being in its DRM USB configuration.

Setup

MacBookPro16,1 — BIOS 2103.160.2.0.0, iBridge 23.16.16068.0.0
Omarchy / Arch, linux-t2 7.1.8.arch1-3 (7.1.8-arch1-Watanare-T2-3-t2), t2bce v0.06
mem_sleep: deep (S3), pm_async=off
Touch Bar either in kernel-HID mode (USB config 1, hid-appletb-kbd) or DRM mode (config 2, appletbdrm bound, tiny-dfr daemon)

Variant A — exactly this issue (event 50 at resume)

2026-09-01 21:19, resume from a 36-min S3 sleep, config 2. Keyboard re-enumerates, then:

21:19:39.003 t2bce_vhci: Unhandled system event: 50 s=0 p1=0 p2=0
21:19:42.141 t2bce_vhci: Possible desync, cmd cancel timed out
21:19:45.213 t2bce_vhci: Possible desync, cmd cancel timed out

Internal keyboard/trackpad dead; forced power-off 8 s later.

Variant B — same desync, no event-50 prodrome (hit twice)

Twice (2026-08-31 21:51 and 2026-09-01 16:02) the resume itself looked completely clean — no Unhandled system event, no command timed out req= anywhere in the boot — but the next suspend entry failed:

15:49:57.294 PM: suspend entry (deep)
16:02:23.928 t2bce_core: remote rejected stateful suspend payload
16:02:23.928 t2bce_vhci t2bce_vhci: remove, state 4
16:02:23.928 t2bce_vhci: Possible desync, cmd cancel timed out
16:02:23.928 t2bce_dma: SQ unregister failed
16:02:23.928 t2bce_dma: CQ unregister failed
             ... (~92 desync/unregister lines, cmd ring slots 0-31)
16:02:23.937 t2bce_core: suspend: exit status=0 stateful_valid=0 no_state_resume=1 no_state_fallback=1
16:02:23.940 t2bce_core: resume: exit status=0 path=no-state ...

bridgeOS answers SAVE_STATE_AND_SLEEP_REJECTED, the no-state fallback tears the VHCI down mid-suspend, every cancel times out, and after the (successful-looking) wake the whole internal USB bus is gone — keyboard/trackpad dead, forced power-off. It reads like the T2 was already silently out of sync since the previous resume, and the rejected stateful payload is just where it finally surfaces.

Note: after a Variant-B failure the T2 is not wedged — the next boot suspends fine, no SMC reset needed.

Correlation with Touch Bar mode (same machine, same kernel, interleaved over 3 days)

Touch Bar mode	cycles	result
config 2 (`appletbdrm` + tiny-dfr)	9	5 OK, 2× Variant B, 1× Variant A, 1× hard hang at `PM: suspend entry`
config 1 (kernel HID, no `appletbdrm`)	~30	0 failures (incl. 9 h sleeps)

Not correlated with: pre-sleep teardown hooks (failures both with systemctl stop tiny-dfr / modprobe -r appletbdrm hooks and with none at all), time since previous resume (failures at 2.5–11 min; successes at 16 s–77 min), or sleep length. Config 2 adds appletbdrm's bulk endpoints plus the touch HID interface, i.e. more transfer queues in play, which would fit a cancellation/resume race being more likely to hit.

Question for @deqrocks

deqrocks/t2bce a973d53 ("t2bce_vhci: resume endpoint before cancelled URB giveback", 2026-08-10) and unmerged PR deqrocks/t2bce#5 both target this race, but the vendored snapshot in linux-t2-patches (1001-Add-t2bce-driver-stack.patch, last updated 2026-08-07) still has the old giveback-before-resume ordering — so 7.1.8 and 7.2.2 builds all ship without it. Is a973d53 expected to cover both variants above, and could the snapshot be refreshed? Happy to test a rebuilt t2bce out of tree — with the config-2 correlation above this reproduces within a day of normal use.

Full journals for all cycles available on request.

The repo I offer contains the code which I think is stable. When T2linux still uses older code this is their decision. Also not sure here about Omarchy. I will not support DHH/Omarchy community since they are vibe coding the living snot out of my code. Nobody knows what's going on there and I don't wanna know. Your comment even is vibe coded. Leave me alone with your shit.

Navigation Menu

Repository navigation

MacBookAir9,1: t2bce_vhci desync after rapid S3 suspend/resume cycles — 'Unhandled system event: 50' on resume, internal keyboard dead, next suspend wedges (linux-t2 7.1.8) #24

Summary

Hardware

Software

Steps to reproduce

Timeline (journal from the affected boot)

Other observations

Questions / suggestions

Setup

Variant A — exactly this issue (event 50 at resume)

Variant B — same desync, no event-50 prodrome (hit twice)

Correlation with Touch Bar mode (same machine, same kernel, interleaved over 3 days)

Question for @deqrocks

Metadata

Assignees

Labels

Type

Projects

Milestone

Relationships

Development

MacBookAir9,1: t2bce_vhci desync after rapid S3 suspend/resume cycles — 'Unhandled system event: 50' on resume, internal keyboard dead, next suspend wedges (linux-t2 7.1.8) #24

Description

Summary

Hardware

Software

Steps to reproduce

Timeline (journal from the affected boot)

Other observations

Questions / suggestions

Activity

xzedx commented on Sep 2, 2026

Setup

Variant A — exactly this issue (event 50 at resume)

Variant B — same desync, no event-50 prodrome (hit twice)

Correlation with Touch Bar mode (same machine, same kernel, interleaved over 3 days)

Question for @deqrocks

deqrocks commented on Sep 2, 2026

Metadata

Metadata

Assignees

Labels

Type

Projects

Milestone

Relationships

Development

Issue actions